Grant-instruments BTDL User Manual

Operating instructionsBlock heaterBTD/BTDL-bio

SYMPTOMPOSSIBLE CAUSEACTION REQUIREDNO DISPLAYUnit not switched on.Unit not connected to power supply.Power supply failure.Fuse blown in unit or plug

6. Maintenance6.2 Replacement of fusesDisconnect from the power supply socket.Remove the IEC power plug from the rear of the unit. Pull out the fuse

7. SpecificationsThe product is designed for operation indoors in a laboratory at altitudes up to 2000m the performance figures quoted within the ambi

8. Guarantee and Service8.1 GuaranteeWhen used in laboratory conditions and according to these working instructions, this product is guaranteed for TW

Page 14BTD/BTDLOperating instructionsVersion 7 - May 2011

Page 15BTD/BDTLOperating instructionsPHMP • PMS-1000 • PHMT POS-300SHAKERS and THERMO SHAKERSPTR-30 • 360° MULTI-FUNCTION ROTATORPTR-60PS-3D • 3D ROTA

Grant Instruments (Cambridge) LtdShepreth, CambridgeshireSG8 6GB Tel: +44 (0)1763 [email protected]: +44 (0)1763 262410Block h

Page 2BTD/BTDLOperating instructionsVersion 7 - May 2011

Contents1 Safety...42 General Information...

1. SafetyThe following symbols mean: Caution: Read these operating instructions fully before use and pay particular attention to

To reduce the risk of eye injury during high temperature operation, use safety goggles or spectacles.Do not touch surfaces which become hot during hig

2. General InformationThe BTD is a digitally controlled dry block heater, with a unique circular block which can accommodate three sizes of microtubes

3. Getting started3.1 UnpackingRemove packing materials carefully, and retain for future shipment or storage of the unit.3.2 The BTD pack includes:

4. Operation of BTDYou can accurately set the temperature and time required for your specific task by utilising controls and .In the following

Continuous pressure on any of the p and q buttons will speed the display increments.Under the action of high temperature (> 85°C) tube caps can ope